Show Entries Per Page

Showing 1 Through 5 of 5 Total Products

Connecticut Microwave Waveguide Dummy Loads loads are made in accordance with MIL-D 3954     

These loads may be mounted vertically, or horizontally and are  equipped with mounting holes in the rear plate to facilitate installation. 

Special versions of our Dummy Loads can be designed to meet specific applications. Our applications Engineers are available for consultation and will be pleased to discuss your requirement. (specs)

 

Coaxial Terminations DC - 2000 MHz  are available up to 100 Watts 

Air Cooled - Medium Power

Connecticut Microwave 707  series loads are made in accordance with MIL-D 3954   and incorporate

 integral  cooling fins.  Although these units are designed to be used under conditions of natural convection , the power rating can be increased up to twice the listed rating by the use of forced air and appropriate baffling. (air flow of approximately 40cfm per kw of total power)

 These loads may be mounted vertically, or horizontally and are  equipped with mounting holes in the rear plate to facilitate installation.


Special versions of the 707  series loads can be designed to meet specific applications. Our applications Engineers are available for consultation and will be pleased to discuss your requirement.

 

50 kW Mismatch

In response to new testing requirements Connecticut Microwave has developed broadband Mismatches of up 50 kW. They are available with connectors up to EIA 6 1/8" flanges.

High Power - Liquid Cooled, Air Cooled

Loads In the 727 series utilize a strong cylindrical aluminum high.pressure-tight case. Internally, extruded transverse aluminum cooling fins, formed as an integral part of the dummy load jacket, effectively carry the heat into the liquid flow path to provide increased heat transfer efficiency. The loads may be operated either vertically or horizontally and are equipped with mounting holes conveniently located in back plate to permit easy installation. The dissipative material is high-temperature ceramic fully qualified and approved to M I L-D.3954., Connecticut Microwave Waveguide Dummy Loads loads are made in accordance with MIL-D 3954     

These loads may be mounted vertically, or horizontally and are  equipped with mounting holes in the rear plate to facilitate installation. 

Special versions of our Dummy Loads can be designed to meet specific applications. Our applications Engineers are available for consultation and will be pleased to discuss your requirement.

 

Liquid Cooled

Liquid Cooled

High Power no space.

Coaxial

Coaxial

 All Coaxial connectors Available

 

Previous  -  1  -  Next

Connecticut Microwave Corporation
1486 Highland Avenue #5, Cheshire, Connecticut 06410 USA
Phone: (203) 250-9678  -  Fax: (203) 250-9688  -  E-Mail: info@connecticutmicrowave.com